MAGNETEK POWER CONVERTER MANUAL

Note there may be DC loads connected directly to the battery that will not be turned off by the converter switch. Putting the switch in this position will disconnect all DC appliances from the converter, eliminating the possibility of the battery being discharged. This switch also has a center “OFF” position for long term stor-age of the RV. NOTE: If batteries are not installed, the DC appliances will only operate when the converter is on and the switch is in the “CON-VERTER” position.

MAGNETEK POWER CONVERTER MANUAL

The manual switch is located behind the plastic converter door and on the lower right hand corner of the faceplate. To operate the DC appliances from battery power, such as when 120 volts AC is not available, the manual “Converter-to-Battery” switch must be in the “BATTERY” position. No user adjustments are necessary.Īll 6626 models (and 6620 models with code “C”) will automati-cally charge and maintain the RV battery while the converter is on, no user adjustments are necessary.įor more information, see the section titled “Automatic Battery Charger”.ġ2 Volts DC From Battery (models 6606, 6612)

An automatic relay will disconnect the battery from the DC appliances and switch them to converter power. To operate DC appliances from the converter, plug in the shore-line cord of the RV to a 120 volt, 30 amp receptacle. No damage will result if the switch is left in the “BATTERY” position, but the DC appliances will be operating from battery power, which will eventually be depleted.ġ2 Volts DC From Converter (models 6620, 6626)

Magnetek power converter